How to remove and insert the battery

To remove the battery

First, undo the seat post quick release and remove the seat post from the bike.

Then, grasp the black rear light holder and slide the battery out of the top tube.

To insert the battery, align the charging port with the charging port cover and slide the battery into the top tube.

Then insert the seat post and close the quick release.

Related Articles
How to remove and re-install the front wheel
TOOLS NEEDED Something soft for the floor to rest your bike onto 4mm allen key REMOVAL INSTRUCTIONS First, disconnect the brakes. To do this simply squeeze the arms together, hold the silver piece and push the small black part down gently to release ...
How should I store my battery?
The lifespan of the battery can be extended by following the tips below: If you’re not using your battery for a long period of time (e.g. for a month or more) you can put the battery in hibernation mode by holding down the power button. In this mode, ...
Why doesn't my battery charge to 100%?
The figure on the display is not terribly accurate (probably +/-5%) – anything above 90% would be considered typical. When your battery starts losing charge after many cycles, that maximum number (97% in this case) will start to decrease, but it ...
How to remove and re-install the rear wheel
TOOLS NEEDED Something soft for the floor, to rest your bike onto Wire cutters or pliers Either a 15mm deep socket, 15mm pedal spanner OR an adjustable spanner REMOVAL INSTRUCTIONS First, remove the chain. The easiest way is to push the chain ...
My battery isn't performing as well as it used to
Firstly, check if the battery is fully charged. If it’s not full charged, charge the battery and test again. If you’re still experiencing problems get in touch. We can run a health check diagnostic on your battery to see what the problem is. If ...