How to install a kickstand

How to install a kickstand



TOOLS NEEDED


Ratchet with deep 15mm socket, or 15mm bike spanner


INSTRUCTIONS


The kickstand should be installed on the non-drive side (the side without the chain).

First, you’ll need to remove the wheel nut using a deep 15mm socket or a 15mm bike spanner / adjustable spanner.

Place the small plastic washer onto the axel – you’ll notice a protruding part on the plastic piece that fits into the slot on the dropout, keeping it in place.

Next, place the kickstand on top of the plastic washer. The kickstand needs to be placed in its lowest position (the axel should be at the top hole).

Screw the wheel nut back on using your fingers initially. Tighten back up using the deep socket or bike spanner. If you have a torque wrench, you should tighten to around 20 N m, but if you don’t have one just tighten as far as you can by hand.

Once attached, the kickstand may need a bit of adjusting until you’re happy with it’s positioning. You can just bend the kickstand slightly until you’re happy.


    • Related Articles

    • How to install front and rear mudguards

      TOOLS NEEDED 4mm allen key 10mm socket or spanner DIAGRAM INSTRUCTIONS - Please find attached to this article FRONT MUDGUARD INSTALLATION Place a 4mm allen key into the screw holding the front light, and a 10mm socket or spanner onto the dome nut on ...

    • How to remove and re-install the rear wheel

      TOOLS NEEDED Something soft for the floor, to rest your bike onto Wire cutters or pliers Either a 15mm deep socket, 15mm pedal spanner OR an adjustable spanner REMOVAL INSTRUCTIONS First, remove the chain. The easiest way is to push the chain ...

    • How to remove and re-install the front wheel

      TOOLS NEEDED Something soft for the floor to rest your bike onto 4mm allen key REMOVAL INSTRUCTIONS First, disconnect the brakes. To do this simply squeeze the arms together, hold the silver piece and push the small black part down gently to release ...

    • How to unbox your FLIT-16

      Unboxing First, carefully open the box using a pen knife or scissors. Try not to damage it as you may need it for the future. Take out any accessories on the top layer of the box, then remove your seat post, manual and folding instructions, charging ...

    • Is the FLIT-16 compatible with a larger chain-ring?

      The FLIT-16 comes with a single speed set up (38T to 9T) as standard. The FLIT-16 is also compatible with 40T or 42T chainrings. If you would like your bike to be shipped with a bigger chainring for higher gearing, contact us at hi@flit.bike when ...