Codes - The Basics
The KitLock is supplied with two factory set codes:
Master Code: 11 33 55 77
User Code: 22 44
When fitted immediately change the Master Code and User Code.
All Master Codes and Sub-Master Codes are 8 digits long.
All User Codes are 4 digits long.
All technician codes are 6 digits long.
The lock ‘open’ time is set at 4 seconds.
Before programming, select the most appropriate function for the application: A) or B) – See special Master Code set up commands.
A) PUBLIC USE
Important Note: This is the default function and is already pre-programmed in new locks. This is the most common function and is used where the same code will be repeatedly used.
B) PRIVATE USE
The user enters their own personal four-digit code twice, the second time to confirm the correct code. This locks the lock. The same code is entered once only to open the lock before being erased and ready for the
next new user. This function is used for short term, multi occupancy applications, e.g. a locker in a leisure centre
CODES The lock has the following code levels:
Master Code can:
Open the lock
Change the Master Code
Set / Change / Delete the Sub-Master and User Code
Select between repeated use and single use codes
Activate/deactivate technician mode
Sub-Master Code can:
User Code can:
Open the lock
Change the User Code
Technician Code can:
A code cannot be programmed into more than one level
Lost Code Procedure
Note: The procedure requires the door to be open
• Remove the rear-fixing bolt and swing the lock over the edge of the door to reveal the battery compartment.
• Remove one battery.
• Press and hold the 1 button, replace the battery, the blue LED will flash twice, release the 1 button. Within three seconds press the 1 button three times. The blue LED will flash twice and the lock will have reverted to the factory master code 11 33 55 77 and all other stored settings will be erased.
• Entering three incorrect codes will cause the lock into shutdown for 10 seconds.
The KitLock should provide well in excess of 15,000 openings, of 4 seconds each, from 2 x AAA 1.5v cells.
When the battery power is low the Red LED will flash 3 times before the Blue LED flashes to signal acceptance of the code. Batteries should be changed as soon as this happens. The lock will operate for 100 times with low battery.
MASTER CODE COMMANDS
Change the MASTER CODE
#Master Code • 01 • New Master Code • New Master Code ••
Example: #11335577 • 01 • 12345678 • 12345678 ••
Result: Master Code has been changed to 12345678.
SUB-MASTER CODE COMMANDS
USER CODE COMMANDS
Change the USER CODE
#User Code • New User Code • New User Code ••
Example: #2244 • 6688 • 6688 ••
Result: User Code now 6688.
SPECIAL MASTER CODE COMMANDS
Set mode A) PRIVATE USE
Set mode B) PUBLIC USE
#Master Code • 24 ••
Example: #11335577 • 24 ••
Result: The lock will now remain open until the next single use code is entered into the lock as follows:
Enter 4 digit code • Confirm 4 digit code ••
Enter the same 4 digit code•• the lock will now open and remain open until next 4 digit code is entered
Note: if lock is in this mode • LED will flash every 5 seconds to indicate the locker is locked.
Set TECHNICIAN CODE
#Master Code • 99 • Technician Code • Technician Code ••
Example: #11335577 • 99 • 555555 • 555555 ••
Result: The lock is automatically set into function B) single use Locker Mode AND allows the programmed Technician Code to open the lock WITHOUT the entered single use code being erased.
Note: If lock is opened with a Master Code the User Code will be erased.
© 2019 Codelocks Ltd. All rights reserved.