Firmware Update

Firmware Update



 

  1. Open the K3 Connect App.
     
  2. Swipe left on the lock and then select the Info section for the lock you would like to update.


     
  3. Select Firmware Version.


     
  4. If new firmware is available for your lock, the Firmware Upgrade screen will open and show you a page similar to the below.


     
  5. Scroll down and touch Transfer Firmware to Lock.

     
  6. You may then be prompted to restart the power on your lock and also put the lock into set up mode. For the K3 Connect locks, enter: #MasterCode  00  1 ••

  7. The upgrade process will take up to 5 minutes. Please ensure you do not move outside of the range of the lock (approximately 10 meters line of sight) or close the application.


     
  8. Lastly when the firmware has been downloaded it will update the lock. Once this has been completed you will see the new firmware version in the lock's info page.

           Note: When prompted to input the setup mode enter   #Master Code • 00  1 ••

​           

  © 2019 Codelocks Ltd.  All rights reserved.

    • Related Articles

    • KL1060/KL1550/KL1000 - Firmware/Time & Date Update

      This step by step will explain how to carry out a firmware update and update the time and date.  If your lock is flashing red and blue and will not accept any NetCodes, this will resolve your issue.   Firmware Update Login to the portal. Navigate to ...
    • KL1000 NetCode/KL1000 RFID/KL1000 Classic - Firmware/Time & Date Update

      This step by step will explain how to carry out a firmware update and update the time and date.  If your lock is flashing red and blue and will not accept any NetCodes, this will resolve your issue.   Firmware Update Login to the portal. Navigate to ...
    • KL1000 NetCode/KL1000 RFID/KL1000 Classic - Firmware/Time & Date Update

      This step by step will explain how to carry out a firmware update and update the time and date.  If your lock is flashing red and blue and will not accept any NetCodes, this will resolve your issue.   Firmware Update Login to the portal. Navigate to ...
    • Update Your Profile Details

      1. To update your profile information, change your cover/profile picture and reset your password first go to the top right hand corner and click on the clog icon then click on profile to open the profile page. Click on update details. you will then ...
    • Lock Cloning

      1. First you will need to set up a lock with the parameters that you will be cloning onto others.  To do this swipe left on the lock’s name, open Info, Parameters and the set your desired parameters.  Note: Parameters can only be cloned to the same ...