Important: You will be prompted to enter your MasterCode before any changes are made to your settings.

Main Settings

From this page, you can change the general settings for your lock.

a)       Daylight Saving Settings – It is important that this is correct as if it is not your codes will become an hour out of sync when DST comes into effect.  Please make sure that this is turned off when the country the lock is in does not adhere to DST.

b)      Lock Location – Write the location of your lock here.

c)       Code Digit Length – You can decide the length of the codes allowed to be used for access. It is important to note that if a 4-digit code is used and the 6-digit option is selected, the code will not work regardless of whether it is in the user list or not.

d)      Code Free Mode – If this is turned on codes will not be required to gain access.

e)      Unlock Lock Time(s) – This setting changes the amount of time the lock remains open for after an authorized code is used.

f)        Master and SubMaster Code – If you need to change your Master/SubMaster code enter the new code here.  Your old MasterCode will still need to be used to upload the changes to the lock.

g)       Locked/Unlocked Status – This allows you to choose if you would like the lock to flash blue when it is in an unlocked status. If this feature is turned on battery life will be significantly reduced.

Important:  After you have made any changes in the Data Manager you will need to select the Save to USB.

User ID Settings

From this section, you can set up each user’s active periods in which they can use their code to gain access.

If a user requires access all the time, you will not need to enable the active period part of the page (right-hand side) as the lock will know that they always need access. But if for example, you wanted to set an active period of Mon – Sun from 09:00 to 17:00, you would need to enable the active period by checking the Enable checkbox on the right-hand side and setting up the parameters. See the user ID 003 in the below image as an example.

It is also possible to set all user’s access time periods at the same time using the section in the bottom right-hand corner. Make sure to select For All Users and Save to USB before uploading the changes to your lock.