Change the NetCode Mode

Change the NetCode Mode


Important note: When using the NetCode, you will only be able to use one mode at a time. For example if you are using Standard (both) mode you will be unable to use ACC or URM. If you change the mode to ACC, then you will be unable to use NetCodes for Standard (Both) or URM. Please note this does not effect your code clients.

 

1. Open the info section by swiping left on your lock in the K3 application.

 


2. Then open 'Parameters'.

 

3. Open 'NetCode Mode'.

 

4. Select the type of NetCode you would like to use on your lock.

Standard Multiple Use = Standard multiple use code
Standard Single Use = Standard one use code
URM (Unlimited Rental Mode) = Unlimited Rental
ACC (Accommodation) = Rental 1 – 21 days

 

5. Now go back to the main lock page, swipe left and re-sync your application/lock.

  © 2019 Codelocks Ltd.  All rights reserved.

    • Related Articles

    • Change the NetCode Mode

      Notice: The C3 Smart App replaced the K3 Connect App on February 14, 2023. For more information on how to download, set up and use C3 Smart with your Codelocks Smart Locks, visit: c3smart.net or contact Codelocks Support. Important note: When using ...

    • NetCode Modes Explained

      Notice: The C3 Smart App replaced the K3 Connect App on February 14, 2023. For more information on how to download, set up and use C3 Smart with your Codelocks Smart Locks, visit: c3smart.net or contact Codelocks Support. Important Notes Please note ...

    • KL1000 NetCode - Switching NetCode Modes

      On the KL1000 NetCode there are a few different NetCode modes available to choose from. This article will explain how to switch in-between them and provide an explanation of each modes features.   Change Mode Sequences To turn on a mode you will need ...

    • NetCode FAQ

      Why is my lock flashing red when I enter the * at the beginning of a NetCode? This is because the lock is currently not set up to allow NetCodes. To fix this, go into the lock's settings in the C3 Smart App, tick the box next to 'NetCode' and then ...

    • NetCode Modes Explained

        Important Notes Please note you cannot run two modes at the same time (standard modes the only exception).  This means you cannot have a Standard mode and Rental mode enabled at the same time.  If you have issued standard NetCodes to users and then ...