What is needed to configure the EMU-1

• Related Articles

• EMU-1 Engine Compatibility and Setup

  In order to confirm that the EMU-1 will be compatible with your system, please identify the manufacturer of the gauges (VDO, Faria, US Marine, Yanmar etc...) and the range of values (40 to 140 degrees C, 0 to 5 Bar etc...).  Once confirmed, refer to ...

• Configuring The EMU-1 with more than 1 Engine

  A single EMU-1 can be used to monitor up to two engines, so long as they both share the same power supply.  For installations where this is not the case, a dedicated EMU-1 will be needed for each engine.  This article will explain how to set up your ...

• How to Upgrade/Downgrade EMU-1 Firmware

  Changing the firmware on an Actisense EMU-1 is a straight forward process, which only requires a PC to run the freely downloadable Actisense Toolkit, and an Actisense NGT-1 to communicate between the NMEA 2000 bus and the PC. For a step by step guide ...

• Configuring the NGW-1 using Toolkit

  For a detailed explanation of using Toolkit to configure the NGW-1, please visit the following Article: https://www.actisense.com/knowledge-base/nmea-2000/ngw-1/configuring-the-ngw-1-using-toolkit/

• Data not displayed from EMU-1

  When the engine information you were expecting from the EMU-1 isn't available on your Multi-Function Display (MFD), we recommend checking the configuration settings of your MFD to ensure it has been setup correctly to receive data from the EMU-1.  ...