Configuring the NGW-1 using Toolkit

• Related Articles

• What is needed to configure the EMU-1

  The Actisense Toolkit configures the EMU-1 - please see the Toolkit Manual for further details of how to use this software. For further information on the default configuration of the EMU-1, and using an NGT-1 to perform the configuration, please ...

• Choosing the Right NGW-1

  "Why do I need an NGW-1?" Due to the incompatibilities between NMEA 0183 and NMEA 2000, an Actisense NGW-1 is needed to bi-directionally convert data between the two standards. For further information on the NGW-1 and the variants, please visit the ...

• Changing/Upgrading Firmware with the NGW-1

  NGW-1 firmware v2.500 and newer Switching between AIS and Standard configurations does not require the firmware to be updated, as Actisense Toolkit can help create the exact configuration by enabling or disabling conversions as required. NGW-1 ...

• NMEA 0183 device not receiving data from NGW-1

  If your NMEA 0183 Listener is not showing any data when connected to the NMEA 0183 output of an NGW-1, the first step for fault finding should be to see if the NGW-1 supports the conversions you need. For more information on the steps taken when ...

• Configuring the NGT-1

  The Application that is being used with the NGT-1 is responsible for configuring the NGT-1 for each session when it opens up the COM port to the NGT-1. For example, NMEA Reader by default will set the NGT-1 to 'Receive:All'. This means that the NGT-1 ...