Configuring Multiple Engines with the EMU-1

Configuring The EMU-1 with more than 1 Engine

A single EMU-1 can be used to monitor up to two engines, so long as they both share the same power supply.  For installations where this is not the case, a dedicated EMU-1 will be needed for each engine.  This article will explain how to set up your EMU-1 when using a single unit for two engines or multiple EMU-1 on the same NMEA 2000 network.

To check whether your engines sensors are compatible with the EMU-1, read this article.

Getting Started

An Actisense NMEA 2000 to PC Gateway (NGT-1) and our freely available Toolkit software are needed to configure your EMU-1.  Please make sure you have these available before starting the configuration process. 

This article explains why the Maretron USB100 can't be used instead of the NGT-1.


For further information on configuring the EMU-1 and how to set it up for more than one engine, please visit:
https://www.actisense.com/knowledge-base/nmea-2000/emu-1/configuring-the-emu-1-with-more-than-1-engine/


    • Related Articles

    • EMU-1 Engine Compatibility and Setup

      In order to confirm that the EMU-1 will be compatible with your system, please identify the manufacturer of the gauges (VDO, Faria, US Marine, Yanmar etc...) and the range of values (40 to 140 degrees C, 0 to 5 Bar etc...).  Once confirmed, refer to ...
    • Data not displayed from EMU-1

      When the engine information you were expecting from the EMU-1 isn't available on your Multi-Function Display (MFD), we recommend checking the configuration settings of your MFD to ensure it has been setup correctly to receive data from the EMU-1.  ...
    • How to Power the EMU-1

      When the gauges are to remain in-circuit, the EMU-1 has to be powered from the same supply that is powering the gauges for the engine that it is monitoring.  The best way to do this is to wire directly from the back of the positive and GND terminal ...
    • Converting Multiple NMEA 0183 Talkers to NMEA 2000

      Unfortunately it is not possible in any NMEA 0183 networking situation to connect the output of more than one Talker to the input of one or more Listener/s.  To convert data from more than one NMEA 0183 Talker to NMEA 2000 you have two choices which ...
    • Converting Engine Data from NMEA 2000 to NMEA 0183

      The conversion of Engine Data PGNs to NMEA 0183 sentences is very limited. Visit this article for more info: https://www.actisense.com/knowledge-base/hottest-articles/converting-engine-data-from-nmea-2000-to-nmea-0183/